MUTOH ValueJet VJ-1204 Instruction Manual Page 93

  • Download
  • Add to my manuals
  • Print
  • Page
    / 110
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 92
5 Troubleshooting
VJ-1204 QUICK REFERENCE
5 Troubleshooting 5-17
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
(3) Printing is blurred
(4) White or black lines appear on printed media
3 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
"4.2.1 Media
type" in the Operation
Manual
"5 Panel setup
menu" in the
Operation Manual
No. Possible cause Remedy Reference
1 Is the loading position of the media
correct?
Set the media correctly.
3.5.2 Setting roll
media
2 Did you set up the origin and print
position?
Cancel or reset the settings of the origin and
print position.
"5 Panel setup
menu" in the
Operation Manual
No. Possible cause Remedy Reference
1 Are you using the recommended
media?
Use the recommended media.
"4.2.1 Media
type" in the Operation
Manual
2 Are you using the thick or thin media? Use the recommended media.
"4.2.1 Media
type" in the Operation
Manual
3 Is the media printed on the printing
surface?
Confirm the printing surface of the media
and set it correctly.
3.5 Setting media
4 Did you perform Alignment? Perform Alignment.
5.1.2 Adjust the
print head
5 Did you perform Media feed
compensation?
Perform Media feed compensation.
"4.2.6 Media
feed compensation" in
the Operation Manual
6 Is each heater set to the appropriate
temperature?
Set it to the appropriate temperature.
"5 Panel setup
menu" in the
Operation Manual
7 Is the head height set to High? Return the head height to "Normal (Low)".
"4.2.5 Head
height adjustment" in
the Operation Manual
No. Possible cause Remedy Reference
1 Are you using the recommended
media?
Use the recommended media.
"4.2.1 Media
type" in the Operation
Manual
2 Is the scroller set correctly? Set the scroller correctly.
3.5.1 Loading roll
media
3 Is the nozzle in good condition? Perform Head cleaning.
4.2.3 Head
cleaning
4 Did you perform Alignment? Perform Alignment.
5.1.2 Adjust the
print head
No. Possible cause Remedy Reference
Page view 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 109 110

Comments to this Manuals

No comments