MUTOH ValueJet VJ-1204 Instruction Manual Page 91

  • Download
  • Add to my manuals
  • Print
  • Page
    / 110
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 90
5 Troubleshooting
VJ-1204 QUICK REFERENCE
5 Troubleshooting 5-15
(2) The media is crumpled during initialization
NOTE
NOTE
If the media is jammed or torn, remove it according to "5.2 When media is jammed".
(3) The wrong media size is set during initialization
6 Are you using folded, torn or rolled
media?
Replace the media.
"4.2.2 Cautions
on handling media" in
the Operation Manual
7 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
"4.2.1 Media
type" in the Operation
Manual
"5 Panel setup
menu" in the
Operation Manual
No. Possible cause Remedy Reference
1 Are you using the recommended
media?
Use the recommended media.
"4.2.1 Media
type" in the Operation
Manual
2 Is the loading position of the media
correct?
Set the media correctly.
3.5.2 Setting roll
media
3 Is the media loaded at an angle? Set the media straight.
3.5.2 Setting roll
media
4 Are there any foreign materials such as
paper attached to the pressurizing
roller?
Clean the pressurizing roller.
4.2.2 Cleaning the
inside of the printer
5 Is the printer used in an environment
other than the one specified, such as
near an air conditioner?
Only use the printer in an environment that
is specified for use.
Installation
manual
6 Are you using folded, torn or rolled
media?
Replace the media.
"4.2.2 Cautions
on handling media" in
the Operation Manual
No. Possible cause Remedy Reference
1 Are you using the recommended
media?
Use the recommended media.
"4.2.1 Media
type" in the Operation
Manual
2 Is the media loaded at an angle? Set the media straight.
3.5.2 Setting roll
media
3 When the media is set, does it curl
upward?
Straighten the media or set a new media.
3.5.2 Setting roll
media
4 Is the printer used in an environment
other than the one specified, such as
near an air conditioner?
Only use the printer in an environment that
is specified for use.
3.5.1 Loading roll
media
5 Are you using media that has been
printed on already?
Use a new media.
"4.2.1 Media
type" in the Operation
Manual
No. Possible cause Remedy Reference
Page view 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 109 110

Comments to this Manuals

No comments