Operations Instruction Osprey 75/102/130
AP-75720, Rev. 2.0 30
Step 9 : Cut a poly-knit wiper into three equal pieces, and place them on the cap sponges.
Notes
• Place a piece of poly-knit wiper on the cap sponge as in the figure below so that the piece fits the
nozzle surface of the head.
• Use the jet-wash fluid to wash the poly-nit wipers.
• Replace the poly-nit wiper in the following cases:
• The poly-nit wiper has dried.
• Stuff such as ink clotting adhered to the poly-nit wiper.
• The poly-knit wiper is dirty with ink, etc.
• The poly-knit wiper has been used for a week. (Replace it once a week.)
• If the cap sponge is too dirty or dried, replace it with a new one included in the product.
• Be sure to reattach the print head cap after the head cleaning.
Step 10 : Using the wash bottle, soak the cap sponges and the poly-nit wipers enough with the jet-wash fluid.
Notes
• Clean the following parts periodically.
o The resin part of print head cap
o The sides of head (i.e. the parts to which ink clotting, etc., can easily adhere)
o The cap sponges
Step 11 : Tilt the print head cap, and insert it to set on the waste fluid box level.
Notes
• When attaching the print head cap, prevent it from touching the nozzle surface of the head.
No. Name
1 Waste fluid box
2 Print head cap
3 Print head
4 Purge plate
Step 12 : Adjust to fit the print head cap and the print head to each other. Raise the print head cap and set
the purge plate.
Step 13 : Close the maintenance cover.
• Ensure that the cover is firmly fixed.
Downloaded From ManualsPrinter.com Manuals
Comments to this Manuals