Operations Instruction Osprey 75/102/130
43 AP-75720, Rev. 2.0 - 28/11/2007
3.2.5 Setting media type
Step 1 : Switch ON the power of the unit, and set the media.
Notes
• Refer to the following sections to load media.
“Loading roll media”
Step 2 : Press the keys below in the control panel to change the settings.
• When changing the type of media: [F1] key
• When changing the setting of the winding unit: [F2] key
• When going over from media loading: [F3] key
• When changing the setting of feed unit: [F4] key
Setup items Key Parameters Descriptions
User 1
User 2
User 3
User 4
User 5
User 6
User 7
User 8
User 9
User 10
User 11
User 12
User 13
User 14
User 15
Media type F1
User 16
Makes setting for media type used for test printing. For
setup values of printing operation, sixteen settings of
"User 1-16" can be set.
Refer to: “Menu setup on the operation panel”
Take-up OUT
Take-up IN
Take-up OUT/IN/OFF F2
Take-up OFF
Sets the operation of the winding unit.
• Take-up OUT: Set when taking up the printable side
• outward
• Take-up IN: Set when taking up the printable side
• inward
• Take-up OFF: Set when not using the winding unit
Lever Up
Lever Up/Down F3
Lever Down
Switches between up and down motion of the
pressurizing lever. Use this when starting over from the
media setup.
Send Out
Send Out/In F4
Send In
Sets the operation of the feed unit.
• Send Out: Set when using the roll media such as the
printable side is outside.
• Send In: Set when using the roll media such as the
printable side is inside.
Notes
• Problems that occur due to usage of media such as printable side with inside are not guaranteed.
Downloaded From ManualsPrinter.com Manuals
Comments to this Manuals