MUTOH Osprey 75 User's Guide download pdf (Page 67)

Operations Instruction Osprey 75/102/130

67 AP-75720, Rev. 2.0 - 28/11/2007

Installing procedure:

Step 1: Load the media so that the distance from the edge of the media to the media loading position is at

least 40 mm.

Refer to: “Loading roll media”

No. Name

1 Roll media

2 Media loading position

Step 2: Align the alignment line on the media retainers to the edge of the media with, and install the media

retainers on the platen as shown on the image below.

No. Name

1 Roll media

2 Media retainers

3 Alignment line

4 Platen

Notes

• When installing the media retainers, be sure that the magnet in the rear does not stick out from the

stainless steel part of the platen to prevent that the media retainers will come off and interfere with the

print head.

Step 3: Make sure that the media retainers do not interfere with the media as it is fed through the printer.

Notes

• If there is interference with the media as it is fed through the printer even after the media holder plate

has been installed, the media retainer should not be used.

• When removing the media retainer, slide the plate on the platen for near side.

Downloaded From ManualsPrinter.com Manuals

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

No comments

MUTOH Osprey 75 User's Guide Page 67