Operations Instruction Osprey 75/102/130
AP-75720, Rev. 2.0 36
3.2.3 Loading roll media
The procedure for loading roll media is explained below.
To load roll media, follow the steps below.
Step 1 : Power ON the unit.
Step 2 : The printer starts the initializing operation.
• The following message is displayed on the operation panel.
Notes
• In the following conditions, follow "Menu setup on the operation panel" and set individual settings.
• When using the winding unit: Set the winding unit setting to "ON"
(Refer to: “Winding unit menu”)
• When not performing media detection during media initialization: Set media detection to "No"
(Refer to: Item “Media detection menu”)
• When using the roll media such as the printable side is outside: Set the feed unit item to "Outside"
(Refer to: “Feed unit menu”)
• When using the roll media such as the printable side is inside: Set the feed unit item to "Inside".
(Refer to: “Feed unit menu”)
Step 3 : Verify that the MEDIA SET lamp of the control panel is unlit.
Step 4 : Press [F2] key to raise the pressurizing roller.
• The MEDIA SET lamp will light (orange).
• The following message is displayed on the operation panel.
Notes
• When raising or lowering the pressurizing roller, you can use the foot switch instead of the control
panel.
Step 5 : Open the front cover.
Step 6 : Install a media core brace in case you use media wider than 2 metre. This to prevent the media will
bend.
Downloaded From ManualsPrinter.com Manuals
Comments to this Manuals