MUTOH Osprey 75 User's Guide Page 79

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 78
Operations Instruction Osprey 75/102/130
79 AP-75720, Rev. 2.0 - 28/11/2007
Step 4: Perform head cleaning according to "Head cleaning before printing".
Notes
For the settings on the purge menu, see table on the next page.
The < > in the table are default factory settings (initial values).
Setup items Key name Parameters Descriptions
The ink colour to be purged is selected.
<All2>
All
All2: Print head purge processes are
performed for each colour at the same
time. This item uses to stabilize condition of
the print head nozzle.
Black
All: Print head purge processes are
performed for each colour
Other: Print head purge processes are
Cyan
Light Cyan
Magenta
Light Magenta
Ink colour F1
Yellow
performed for the selected colour
Economy
(All2 only)
<Normal>
Powerful
(All2 only)
Continuous
The amount of ink discharged during the purge
process is selected.
Economy: The ink is discharged less than
in the "Normal" mode.
Normal: Recommended in this process.
Powerful: The ink is discharged more than
in the "Normal" mode. Select when the print
head can not be recovered by performing
"Normal" mode.
Continuous: Purge process is performed
individually for "Normal" mode.
Purge mode F2
[CANCEL] key: Finishes the purge process
when "Normal" mode is selected.
Step 5: After head cleaning, perform nozzle check printing again, and check the condition of the head.
Notes
If the smearing or misprinting has not been solved after performing a cleaning one time, change the
ink colour and the purge mode to the following settings, then repeat the head cleaning.
o Ink colour: except "All2"
o Purge mode: "Normal"
If the smearing or misprinting has not been solved after performing a cleaning a few times, please
refer to: Troubleshooting", and take appropriate measures.
If printing problems are not corrected by increasing purge mode to "Powerful", clean off the print head
surface using a poly-knit wiper soaked in jet wash fluid, then perform head cleaning again.
Downloaded From ManualsPrinter.com Manuals
Page view 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 87 88

Comments to this Manuals

No comments