MUTOH Osprey 75 User's Guide download pdf (Page 39)

Operations Instruction Osprey 75/102/130

39 AP-75720, Rev. 2.0 - 28/11/2007

Step 11 : Rewind the roll media a little by pressing the [F1] key on the operation panel while holding the edge

of the media, and eliminate any loose or slant.

Notes

• If you set the roll media free while rewinding, the roll media will fall out from the media feed slot to the

rear side of the product.

• Make sure not to set the right edge of the media over the media setting position. If doing so, it may

affect the printing quality.

Notes

• When setting the roll media, set the both side of the media at least 5mm apart from the edge of the

pressurizing roller. Slippage or creases may occur during printing.

No. Name

1 Roll media

2 Pressurizing roller

Step 12 : If the edge of the roll media is set apart 5mm or less from the edge of the pressurizing roller, adjust

the position of the roll media according to the following procedure:

• Release the right and left fixing levers of the feed units, and move the roll media to the left or right.

• After moving the roll media, fix it again with the fixing levers.

Notes

• When a feed unit is fixed, it fixes pressing a feed unit against a product side.

No. Name

1 Feed unit (Left)

2 Feed unit (Right)

3 Roll media

4 Fixing lever

Downloaded From ManualsPrinter.com Manuals

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 87 88

No comments

MUTOH Osprey 75 User's Guide Page 39