User’s Guide ValueJet 1204
Chapter 4: Handling the printer
84 AP-75740 – Rev 1.2 – 6/07/2011
4.8.1.11 Dryer menu
Set up the After Heater temperature. Set this menu to dry the print.
Notes
• Temperature to be set for the after Heater varies depending on the media which is used for
recommended temperature settings of the after Heater; refer to the "Recommended media list".
Setup Item Setting Value Description
After Heater
Off / <30° C> to 50° C
Set up the after Heater temperature.
1. Roll media
2. Dryer- After heater
3. Print head
—
• [Enter] key: Save the setting and shift to the
previous hierarchy.
• [Cancel] key: Cancel the setting and shift to
the previous hierarchy.
4.8.1.12 StandbyHeating menu
Set up whether each heater is preheated (idle heat) while in standby mode.
Setup Item Setting Value Description
StandbyHeating Off Idle heat is not performed.
<On> Idle heat is performed.
—
• [Enter] key: Save the setting and shift to the previous
hierarchy.
• [Cancel] key: Cancel the setting and shift to the previous
hierarchy.
4.8.1.13 Vacuum Fan menu
Set up the vacuum fan operation.
Setup Item Setting Value Description
Vacuum Fan
Low Set when using soft media.
<High> Set when regular media is used.
—
• [Enter] key: Save the setting and shift to the previous
hierarchy.
• [Cancel] key: Cancel the setting and shift to the previous
hierarchy.
Comments to this Manuals