User’s Guide ValueJet 1204
Chapter 4: Handling the printer
62 AP-75740 – Rev 1.2 – 6/07/2011
Step 2 : Perform the initial adjust print.
• Press the [Enter] key.
o The operation panel displays "Feed Length: 250 mm".
Notes
• The length that media is fed (feeding length) for initial adjustment printing is normally set at 250
mm.
• If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] or [–] key and change the set value.
• Press the [Enter].
o The operation panel displays "Printing".
o Start Initial adjustment printing.
N° Name
1 Feed length
2 Media feeding direction
o When the initial adjustment printing is complete, the printer enters the normal
status
• After the initial adjustment printing, cut the media. Refer to “Cutting media”
Step 3 : Measure the distance between two pluses in the initial adjustment print using a measurement
tool, such as a ruler.
Step 4 : Set up Initial Adjust Change.
• Press the [+] or [–] key to select "PF2: Init.Adj.Change".
• Press the [Enter] key.
o The operation panel displays "Init: 250.0/250mm".
• Press the [+] or [–] key and enter the measured value in step 3.
• Press the [Enter] key.
o The initial adjustment value is saved.
o The operation panel displays "PF2: Init.Adj.Change".
Step 5 : Perform the Confirm Print.
• Press the [+] or [–] key to select "PF3: Confirm Print".
• Press the [Enter] key.
The operation panel displays "Feed Length: 250 mm".
Comments to this Manuals