MUTOH SC-650 User's Guide download pdf (Page 70)

User’s Guide SC-PRO Cutting Plotter

CHAPTER 5 : FINETUNING YOUR CUTTER

AP-75280 – Rev. 1.2

325 mm

445 mm

5.4 EPOS TEST CUTS

To be able to contour cut, an Epos® feature has been incorporated. This feature will search for the

Reference box and measure the position of the design(s).

When you establish some miscalculations during contour cutting, it is recommended to perform the test cuts

described below.

After these test, everything should be all right. If not, please contact an Authorized Mutoh Technician.

5.4.1 EPOS alignment

5.4.1.1 Tools necessary:

► SC-Pro.

► Host Computer with the Mutoh CutServer installed on.

► EPOS final check chart pre-printed on vinyl or paper.

► Drag knife when testing on vinyl.

► Pressurized ballpoint pen when testing on paper.

5.4.1.2 Alignment procedure

Step 1 : Load the appropriate tool (a knife on vinyl and a pen on

paper).

Step 2 : Power ON the cutter and be sure that the lever is raised.

Step 3 : Press the [TOOL] button and set the tool you are using.

Tool

Pen

Start: Exit:

Tool

Knife

Start: Exit:

Step 4 : Set the media type to “Sheet”.

Step 5 : Insert the test sheet as described in the chapter “Loading sheet media” with the arrow in the top

right corner and the outer pressure rollers outside the reference box. The middle pressure rollers

may be disabled.

Step 6 : Pull the lever down.

Step 7 : Set your speed and force values accordingly.

Step 8 : Make sure there is a connection between the Mutoh CutServer and the cutter by selecting the

checkbox near to the requested cutter.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 107 108

No comments

MUTOH SC-650 User's Guide Page 70