User’s Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
52
AP-75280 – Rev. 1.2
4.2.7 Origin
Change / control the default origin after a media load sequence.
Notes
Please make sure media is loaded. If this is not the case, the SC-Pro positioning calculation is based on
previously installed media.
Origin
L RIGHT
Save: Exit:
Origin L RIGHT
The origin will be set in the lower right corner.
CENTER The origin will be set in the centre.
U RIGHT The origin will be set in the upper right corner.
U LEFT The origin will be set in the upper left corner.
L LEFT The origin will be set in the lower left corner.
4.2.8 Laser speed
It is possible to perform a test contour cutting with the SC-Pro cutting plotter. Contour lines will be indicated
by the EPOS laser beam. In case the speed of the test contour cutting is not acceptable, you can decrease
or increase the speed.
Laser Speed
15
[cm/s]
Save: Exit:
Laser Speed 2 – 15 – 100 [cm/s]
Laser speed can be set between 2 and 100 cm / s
Notes
The laser speed has nothing to do with the speed of measuring a frame.
Pre-Feed Length
MediaWidth
REAR
FRONT
U LEFT U RIGHT
L LEFT L RIGHT
CENTER
Comments to this Manuals