MUTOH SC-650 User's Guide download pdf (Page 53)

User’s Guide SC-PRO Cutting Plotter

CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL

AP-75280 – Rev. 1.2

4.2.9 Tool-up speed

Tool-up movements are mostly long movements (which reach their maximum speed) between the short tool-

down movements. These movements could cause abrupt media transport (which could cause tracking

problems). Therefore, it is recommended to select a tool-up speed lower than the speed selection in the

menu.

Tool- up Speed

100

[cm/s]

Save: Exit:

Tool-up Speed 2 -100 [cm/s]

Tool-up speed can be set between 2 and 100 cm / s

4.2.10 Job focus

A lot of advanced cutting settings will be made in the background without any need of intervention by the

end-user. Select by means of the table below the correct job settings (focus)

Job Focus

Accuracy

Save: Exit:

Job Focus Accuracy

Give in some speed, gain quality.

Speed Give in some quality, gain speed.

4.2.11 Smoothing

Smoothing can be ENABLED or DISABLED. Depending on your choice, cutting of obtuse angles will be

dealt differently by the cutter.

If the complementary angle between two consecutive vectors A & B is larger than the smoothing angle, the

cutter will slow down and cut a sharp corner (1). If the angle is smaller, the cutter will maintain its speed and

cut a rounded corner (2). The optimum smoothing angle is calculated internally.

When smoothing is DISABLED all corners will be cut sharply.

Smoothing

ENABLED

Save: Exit:

Smoothing ENABLED

Smoothing has been enabled (recommended)

DISABLED Smoothing has been disabled

= 30°

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 107 108

No comments

MUTOH SC-650 User's Guide Page 53