User’s Guide – Osprey 75/102/130
Chapter 6: Printer menu
143 AP-75102, Rev. 2.0, 28/11/2007
6.5.4.6 Feed unit menu
Sets the operation of the feeding unit.
Setup items Parameters Descriptions
Inside Set when using roll media with the printable side inside.
<Outside> Set when using roll media with the printable side outside.
Load Unit
–
After setting, shift to the previous hierarchy menu.
Refer to: “Utility menu”
6.5.4.7 Negative pressure pump menu
The operational pressure of the vacuum pump is set here.
Notes
• Adjust the working pressure of the negative pressure pump when:
o Printing becomes smeared or misprinted and cannot be corrected by performing head cleaning:
increase the parameter
• Ink drips from the print head face during ink replenishment: decrease the parameter “Text normal”.
Setup items Parameters Descriptions
Neg Press
-3.0kPa to <2.1kPa>
to -1.5kPa
Change the operating pressure of negative pressure
pump by operating the following keys.
• [F2] key: Increases setup value.
• [F4] key: Decreases setup value.
• [ENTER] key: To confirm setup value, shifts to the
previous hierarchy menu.
• [CANCEL] key: To cancel setup value, shifts to the
previous hierarchy menu.
Refer to: “Utility menu”
6.5.4.8 Slant check menu
Set to detect a slant while feeding media.
Setup items Parameters Descriptions
OFF No slant check.
<ON> To perform check.
Paper slant
–
[CANCEL] key: Shift to the previous hierarchy menu.
Refer to: “Utility menu”
Comments to this Manuals