MUTOH Osprey 102 User's Guide Page 142
- Page / 176
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
User’s Guide – Osprey 75/102/130
Chapter 6: Printer menu
142 AP-75102, Rev. 2.0, 28/11/2007
6.5.4.4 Media width menu
When media detection is not performed during media initialization, the distance between the media loading
position and the left edge of media (paper width) is set here.
Notes
• If the set value is larger than the media width set by the media width menu, media and product may be
tainted by ink during printing.
Setup items Parameters Descriptions
210mm to <841mm> to
2600mm
To change media width by operating the
following keys.
• [F2] key: Increases setup value.
• [F4] key: Decreases setup value.
• [ENTER] key: To confirm setup value,
shifts to the previous hierarchy menu.
• [CANCEL] key: To cancel setup value,
shifts to the previous hierarchy menu.
Refer to: “Utility menu”
6.5.4.5 Winding unit menu
Sets Winding unit operation during printing.
Setup items Parameters Descriptions
<OFF> No use of winding unit.
Outside Sets in outer winding.
Inside Sets in inner winding.
Take Up Unit
–
After setting, shifts to the previous hierarchy menu.
Refer to: “Utility menu”
- User’s Guide 1
- WEEE regulations 3
- Important Notice 5
- Warranty Limitations 7
- About This Manual 7
- TABLE OF CONTENTS 9
- 1 SAFETY INSTRUCTIONS 11
- 1.1 INTRODUCTION 12
- 1.4 WARNING LABELS 16
- 1.5 OPERATION LABELS 20
- 2 PRODUCT OVERVIEW 23
- 2.1 FEATURES 24
- 2.2 PARTS NAME AND FUNCTIONS 25
- 2.2.2 Rear section 26
- 2.2.3 Operation panel 27
- 2.3 IN-THE-BOX CONTENT 29
- 2.3.3 Starterkit 30
- 2.3.4 Core Brace Set 30
- Chapter 2: Product Overview 32
- 3 BASICS 33
- 3.1.1 Switching the power ON 34
- 3.2.1 Installing roll media 42
- 3.2.3 Loading roll media 45
- 3.2.4 Setting winding unit 50
- 3.2.5 Setting media type 52
- 3.2.6 Replacing roll media 53
- Replacement procedure 54
- (1) Refilling period 56
- (2) Types 57
- (3) Refilling procedure 57
- 3.4 DISPOSAL OF WASTE FLUIDS 58
- (1) Before the transfer 60
- (2) After the transfer 61
- Chapter 3: Basics 66
- 4 PERIODICAL MAINTENANCE 67
- 4.1 CLEANING THE PRINTER 68
- (2) Cleaning Procedure 70
- (1) Cleaning period 70
- No. Name 72
- 4.2.1 Replacing ink filter 76
- 5.1 USING MEDIA 78
- 5.1.4 The printing area 79
- 5.2 TESTPRINTING 87
- 5.2.1 Setup List 89
- 5.2.2 Nozzle Check 90
- 5.2.3 Alignment 91
- 5.2.4 Palette 92
- 5.4 PRINTING FLOW 95
- 6 PRINTER MENU 97
- Chapter 6: Printer menu 98
- 6.1 HOW TO WORK IN THE MENU 100
- 6.2.1 [F1] – Cancel 102
- 6.3.1 Parameter change 107
- 6.3.2 Heater 108
- 6.3.4 Changing Printing Mode 109
- 6.5.1 Setup menu 1/5 114
- 6.5.1.2 Test print menu 115
- 6.5.1.3 Media setup menu 116
- 6.5.1.4 Media type menu 116
- 6.5.1.5 User media menu 117
- 6.5.1.6 Ink Dry menu 118
- 6.5.1.7 Head Height menu 118
- 6.5.1.11 Drier menu 120
- 6.5.1.12 Prev. Stick menu 120
- 6.5.1.16 Print Unit menu 123
- 6.5.1.17 Print depth menu 123
- 6.5.1.18 Data size menu 124
- 6.5.1.19 PF size menu 124
- 6.5.1.20 CR size menu 125
- 6.5.1.21 Idle heat menu 125
- 6.5.1.24 Set review menu 127
- 6.5.2 Setup Menu 2/5 128
- 6.5.2.4 Interlace Setup menu 129
- 6.5.2.5 Priority menu 129
- 6.5.2.7 Repeat printing menu 130
- 6.5.2.8 Repeat times menu 130
- 6.5.2.9 Interval time menu 131
- 6.5.2.10 Effect setup menu 131
- 6.5.2.11 Command setup menu 132
- 6.5.2.14 Layout setup menu 133
- 6.5.2.15 Joint printing menu 133
- 6.5.2.16 Joint margin menu 134
- 6.5.2.17 Function setup menu 134
- 6.5.2.18 CMY→K menu 135
- 6.5.2.19 Mirror menu 135
- 6.5.3 Setup menu 3/5 136
- 6.5.3.3 Centronics menu 137
- 6.5.3.4 Network setup menu 137
- 6.5.3.5 IP address menu 138
- 6.5.3.6 Subnet mask menu 138
- 6.5.3.7 Gateway menu 139
- 6.5.3.8 Backup menu 139
- 6.5.4 Setup menu 4/5 140
- 6.5.4.2 Error Display menu 141
- 6.5.4.3 Media detection menu 141
- 6.5.4.4 Media width menu 142
- 6.5.4.5 Winding unit menu 142
- 6.5.4.6 Feed unit menu 143
- 6.5.4.8 Slant check menu 143
- 6.5.4.9 Flushing menu 144
- 6.5.4.10 Mode Print 144
- 6.5.4.12 Write mode menu 146
- 6.5.4.13 Reprint menu 147
- 6.5.4.14 File delete menu 148
- 6.5.4.15 Re-name menu 149
- 6.5.4.16 Format menu 150
- 6.5.5 Setup menu 5/5 156
- 6.5.5.2 Head wash menu 157
- 6.5.5.5 Mode print menu 160
- 7 TROUBLESHOOTING 161
- 7.1 INTRODUCTION 162
- 7.3 ERROR MESSAGES 168
- 7.4 WHEN MEDIA JAMS OCCUR 174
Related products and manuals for Print & Scan MUTOH Osprey 102
Print & Scan MUTOH Winder 30 User's Guide
(39 pages)
(39 pages)
Print & Scan MUTOH ValueJet 1604 User Manual
(71 pages)
(71 pages)
Print & Scan MUTOH PJ-2216NXE Specifications
(298 pages)
(298 pages)
(66 pages)
Print & Scan MUTOH RJ600EX-B-01 User's Guide
(100 pages)
(100 pages)
Print & Scan MUTOH RJ600EX-B-01 User's Guide
(110 pages)
(110 pages)
Print & Scan MUTOH PJ-2216NXE User's Guide
(266 pages)
(266 pages)
Print & Scan MUTOH VJ-1324 User Manual
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 2.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals